![]() When the machine boots up check the proc settings. # service network restart # Or restart server ![]() Restart the network, or restart the server. # modprobe bonding Step 5 : Restart Network interface and verify Load the bond driver module from the command prompt. Options bond0 mode=1 miimon=100 Step 4 : Activate bonding driver A value of zero disables MII link monitoring. This determines how often the link state of each slave is inspected for link failures. Specifies the MII link monitoring frequency in milliseconds. The modes areĪdd the following lines to /etc/nf. Select the network bonding mode based on you to need, documented at the bottom of this article. Set the parameters for bond0 bonding kernel module. SLAVE=yes Step 3 : Decide on bonding mode SLAVE=yes # cat /etc/sysconfig/network-scripts/ifcfg-eth2 SLAVE=yes # cat /etc/sysconfig/network-scripts/ifcfg-eth1 # cat /etc/sysconfig/network-scripts/ifcfg-eth0 Make sure you add the MASTER and SLAVE configuration in these files. Comment out, or remove the ip address, netmask, gateway and hardware address from each one of these files, since settings should only come from the ifcfg-bond0 file above. Modify eth0, eth1 and eth2 configuration as shown below. ONBOOT=yes Step 2 : Update interface files (ifcfg-eth*) # cat /etc/sysconfig/network-scripts/ifcfg-bond0 Shown below is my test bonding config file. Create the file ifcfg-bond0 with the IP address, netmask and gateway.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |